Ignition Switch: Service and Repair

IGNITION SWITCH REMOVAL
The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before removing ignition switch.
1. Remove key cylinder.
2. Remove lower steering column cover screws and remove cover.
3. Remove the multi-function switch.
4. Disconnect the electrical connector at the rear of the ignition switch.





5. Remove the ignition switch mounting screw. Use tamper proof torx bit to remove the screw.





6. Pull the ignition switch straight out to remove from the locking tabs

IGNITION SWITCH INSTALLATION
The ignition key must be in the key cylinder for cylinder installation. The key cylinder must be aligned with the ignition switch for installation.





1. Before installing ignition switch, rotate the slot in the switch to the ON position.
2. Connect the electrical connector to rear of ignition switch. Make sure that locking tab is fully seated into wiring connector.
3. Position the switch to the column and install tamper proof screw. Tighten screw to 3 Nm (26 inch lbs.).
4. Test the operation of the lock cylinder for smooth rotating.
5. Install the multi-function switch.
6. Install steering column lower cover.