Bearing Retainer

BEARING RETAINER
REMOVAL
1. Remove release bearing and lever from the transmission.
2. Remove the bolts holding the front bearing retainer to the transmission case.
3. Remove the front bearing retainer from the transmission case.
4. With a pry tool, remove the front bearing retainer seal.

INSTALLATION





1. Install new seal in the front bearing retainer with Tool Handle C-4171 and Installer 8211 (Fig. 97).
2. Remove any residual gasket material from the sealing surfaces of the bearing retainer and the transmission case.
3. Install new front bearing retainer gasket to the front bearing retainer.
4. Install the front bearing retainer onto the transmission case.
5. Install the bolts to hold the bearing retainer onto the transmission case.
6. Tighten the bolts to 17 Nm (12 ft. lbs.).
7. Install release bearing and lever onto the transmission.