Power Distribution Center Support Bracket Replacement
REMOVAL1. Disconnect and isolate the battery negative cable.
2. Remove the Power Distribution Center (PDC) from the PDC bracket. Refer to Power Distribution Center for the location of the proper PDC removal procedures.
Fig.15 PDC Bracket:
3. Remove the three screws that secure the PDC bracket to the right front inner fender (Fig. 15).
4. Remove the PDC bracket from the right front inner fender.
INSTALLATION
1. Position the PDC bracket onto the right front inner fender.
2. Install and tighten the three screws that secure the PDC mounting bracket to the right front inner fender. Tighten the screws to 3.9 Nm (35 in. lbs.).
3. Install the PDC onto the PDC bracket. Refer to Power Distribution Center for the location of the proper PDC installation procedures.
4. Reconnect the battery negative cable.