Manifold Pressure/Vacuum Sensor: Service and Repair

REMOVAL

Fig.33 Throttle Body And Sensor Locations:

Fig.34 Throttle Body And Sensor Locations:

The MAP sensor is mounted to the side of the throttle body. An L-shaped rubber fitting is used to connect the MAP sensor to throttle body.

1. Remove air cleaner intake tube at throttle body.

Fig.28 MAP Sensor Mounting:

2. Remove two MAP sensor mounting bolts (screws).
3. While removing MAP sensor, slide the rubber L-shaped fitting from throttle body.
4. Remove rubber L-shaped fitting from MAP sensor.

INSTALLATION
The MAP sensor is mounted to the side of the throttle body. An L-shaped rubber fitting is used to connect the MAP sensor to throttle body.

1. Install rubber L-shaped fitting to MAP sensor.
2. Position sensor to throttle body while guiding rubber fitting over throttle body vacuum nipple.
3. Install MAP sensor mounting bolts (screws). Tighten screws to 3 Nm (25 in. lbs.) torque.
4. Install air cleaner intake tube.