AX5 Manual Transmission

ADAPTER HOUSING SEAL

REMOVAL
1. Hoist and support vehicle.
2. Remove transfer case.





3. With a pry tool or slide hammer mounted screw, remove the adapter housing seal (Fig. 95).

INSTALLATION
1. Clean seal bore of adapter housing of any residual sealer material from original seal.





2. Instal new seal with Handle C-4171 and Installer 8208. Install new seal so that the seal is located 0 ± 0.2 mm (0 ± 0.008 inch) to the seal bore face of adapter housing (Fig. 96).
3. Install transfer case.
4. Check and add fluid to transmission as necessary.
5. Lower vehicle.