Front Washer Pump/Motor Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.

Fig.9 Front Washer Pump/Motor Remove/Install:

2. Disconnect the washer supply hose from the barbed outlet nipple of the front washer pump/motor unit and allow the washer fluid from the washer reservoir to drain into a clean container for reuse.
3. Disconnect the headlamp and dash wire harness connector for the front washer pump/motor from the washer pump/motor connector receptacle.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the barbed inlet nipple of the front washer pump out of the rubber grommet seal in the washer reservoir. Care must be taken not to damage the washer reservoir.
5. Remove the front washer pump/motor unit from the washer reservoir.
6. Remove the rubber grommet seal from the front washer pump/motor mounting hole in the washer reservoir and discard.

INSTALLATION
1. Install a new rubber grommet seal into the front washer pump/motor mounting hole of the washer reservoir.
2. Position the front washer pump/motor unit inlet nipple to the washer reservoir.
3. Using hand pressure, firmly and evenly press the barbed inlet nipple of the front washer pump/motor unit through the rubber grommet seal and into the washer reservoir. Care must be taken not to damage the washer reservoir.
4. Reconnect the headlamp and dash wire harness connector for the front washer pump/motor to the washer pump/motor connector receptacle.
5. Reconnect the washer supply hose to the barbed outlet nipple of the front washer pump/motor unit.
6. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
7. Reconnect the battery negative cable.