Horn: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.

Fig.1 Horns Remove/Install:

2. Disconnect the wire harness connectors from the horn connector receptacles.
3. Remove the two screws that secure the horn and mounting bracket units to the left front inner fender shield.
4. Remove the horn and mounting bracket units from the left front inner fender shield.

INSTALLATION
1. Position the horn and mounting bracket units onto the left front inner fender shield.
2. Install and tighten the screw that secures the horn and mounting bracket units to the left front inner fender shield. Tighten the screw to 6.8 Nm (5 ft. lbs.).
3. Reconnect the wire harness connectors to the horn connector receptacles.
4. Reconnect the battery negative cable.