Starter Relay: Service and Repair
REMOVAL1. Disconnect and isolate battery negative cable.
Fig.16 Power Distribution Center:
2. Unlatch and open cover on Power Distribution Center (PDC) (Fig. 16).
3. See fuse and relay layout label affixed to underside of PDC cover for starter relay identification and location.
4. Remove starter relay from PDC.
INSTALLATION
1. See fuse and relay layout label affixed to underside of PDC cover for proper starter relay location.
2. Position starter relay in proper receptacle in PDC.
3. Align starter relay terminals with terminal cavities in PDC receptacle.
4. Push down firmly on starter relay until terminals are fully seated in terminal cavities in PDC receptacle.
5. Close and latch PDC cover.
6. Connect negative battery cable.