Rear

REMOVAL - REAR DISC BRAKE PADS
1. Raise and support vehicle.
2. Remove the wheel and tire assemblies.
3. Compress the caliper.
4. Remove the caliper.
5. Remove the caliper by tilting the top up and off the caliper adapter.

NOTE: Do not allow brake hose to support caliper assembly.

6. Support and hang the caliper.
7. Remove the inboard brake pad from the caliper adapter.
8. Remove the outboard brake pad from the caliper adapter.

INSTALLATION - REAR DISC BRAKE PADS
1. Bottom pistons in caliper bore with C-clamp. Place an old brake shoe between a C-clamp and caliper piston.
2. Clean caliper mounting adapter and anti-rattle springs.
3. Lubricate anti-rattle springs with Mopar brake grease.
4. Install anti-rattle springs.

NOTE: Anti-rattle springs are not interchangeable.

5. Install inboard brake pad in adapter.
6. Install outboard brake pad in adapter.
7. Tilt the top of the caliper over rotor and under adapter. Then push the bottom of the caliper down onto the adapter.
8. Install caliper.
9. Install wheel and tire assemblies and lower vehicle.
10. Apply brakes several times to seat caliper pistons and brake shoes and obtain firm pedal.
11. Top off master cylinder fluid level.