Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2004 >> Liberty 2WD V6-3.7L VIN K >> Repair and Diagnosis >> Transmission and Drivetrain >> Manual Transmission/Transaxle >> Service and Repair >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation



INSTALLATION / NV3550 Manual Transmission
1. Install clutch housing on transmission and tighten housing bolts.

housing bolts 46 Nm (34 ft. lbs.).


2. Lubricate contact surfaces of release fork pivot ball stud and release fork with high temp grease.
3. Install release bearing, fork and retainer clip.
4. Position and secure transmission on transmission jack.
5. Lightly lubricate the transmission input shaft splines with Mopar high temp grease.
6. Raise transmission and align transmission input shaft and clutch disc splines. Then slide transmission into place.
7. Install clutch housing-to-engine bolts and tighten.

clutch housing-to-engine bolts 58 Nm (43 ft. lbs.).

NOTE: Be sure the housing is properly seated on engine block before tightening bolts.

8. Install shift tower and bolts. Tighten bolts.

shift tower bolts 7 - 10 Nm (5 - 7 ft. lbs.).

9. Install rear crossmember and tighten crossmember bolts.

crossmember bolts 41 Nm (31 ft. lbs.)


10. Install transmission mount bolts and tighten.

transmission mount bolts 54 Nm (40 ft. lbs.).


11. Install exhaust bracket to crossmember.
12. Remove support stands from engine and transmission.
13. Install transfer case, shift cable and vent hose if equipped.
14. Install wire connectors to transmission/transfer case.
15. Install propeller shaft/shafts.
16. Install slave cylinder in clutch housing.
17. Fill transmission and transfer case if equipped, with recommended lubricants.
18. Install skid plate if equipped.



EXTENSION HOUSING BUSHING / INSTALLATION
1. Align bushing oil hole with oil slot in rear housing.
2. Tap bushing into place with Installer 6951 and Handle C-4171.






3. Install new oil seal in housing using Installer C-3972-A (Fig. 131).
4. Install propeller shaft with reference marks aligned.
5. Remove support and lower vehicle.
6. Check transmission fluid level.




EXTENSION HOUSING SEAL / INSTALLATION
1. Place seal in position on transmission housing.






2. Drive new seal into transmission housing with Installer C-3972-A and Handle C-4171 (Fig. 133).
3. Carefully guide propeller shaft slip yoke into housing and onto output shaft splines.
4. Install propeller shaft with reference marks aligned.
5. Remove support and lower vehicle.
6. Check transmission fluid level.

pro multis · About Operation CHARM