PDC Housing Lower Cover

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Unlatch and remove the cover from the PDC.
3. Unlatch and remove the B(+) terminal stud cover from the PDC.
4. Remove the two nuts that secure the eyelet terminal to the two B(+) terminal studs of the PDC.
5. Remove the eyelet terminal from the PDC B(+) terminal studs.
6. Disengage the latches on the PDC mounts from the tabs on the PDC bracket stanchions, and pull the PDC housing upward to disengage the mounts from the stanchions of the bracket.

PDC Housing Lower Cover Remove/Install - Typical:

7. Using a trim stick or another suitable wide flat-bladed tool, gently pry the latches on each side and one end of the PDC housing that secure the housing lower cover to the PDC and remove the housing lower cover.

INSTALLATION
1. Align the PDC housing lower cover to the bottom of the PDC.
2. Press the PDC housing lower cover gently and evenly onto the PDC until each of the latches that secure the cover to the PDC is fully engaged.
3. Engage the mounts on the PDC housing with the stanchions of the PDC bracket and push the unit downward until the mount latches fully engage the mounting tabs on the PDC bracket.
4. Install the eyelet terminal over the two PDC B(+) terminal studs.
5. Install and tighten the two nuts that secure the eyelet terminal to the B(+) terminal studs. Tighten the nuts to 11.3 N.m (100 in. lbs.).
6. Install the B(+) terminal stud cover onto the PDC.
7. Install the cover onto the PDC.
8. Reconnect the battery negative cable.