Programming the Sentry Key Remote Entry Module (SKREEM)

1. Turn the ignition switch to the On position (transmission in Park/Neutral).
2. Use the scan tool and select THEFT ALARM, SKREEM, then MISCELLANEOUS.
3. Select PCM REPLACED (GAS ENGINE).
4. Program the vehicle four-digit PIN into SKREEM.
5. Select COUNTRY CODE and enter the correct country

NOTE: Be sure to enter the correct country code. If the incorrect country code is programmed into SKREEM, it cannot be changed and the SKREEM must be replaced.

6. Select YES to update VIN (the SKREEM will learn the VIN from the PCM).
7. Press ENTER to transfer the secret key (the PCM will send the secret key to the SKREEM).
8. Program ignition keys to the SKREEM.

NOTE: If the PCM and the SKREEM are replaced at the same time, all vehicle ignition keys will need to be replaced and programmed to the new SKREEM.