Re-Initialization

NOTE:
- If for some reason the sunroof is not operating normally it may be necessary to re-initialize the sunroof assembly. This procedure should be attempted prior to any diagnosis of the sunroof system.
- The re-initialization procedure is not complete if any one of the following conditions occurs before the re-initialization procedure is completed:

The sunroof switch is not held in the CLOSE position.
- The ignition or battery power is lost.
- The glass panel has not reached its closed position.

NOTE: if the re-initialization procedure is not carried out completely, it must be started over.

1. Cycle the sunroof to full "VENT" position.
2. Once the sunroof is in the full "VENT" position, press and continuously hold the "CLOSE" button on the sunroof switch.
3. After a delay of 10 seconds the sunroof will begin to move past the normal "VENT" position to the hard stop position. It will then reverse to the normal "VENT" position also known as the soft stop. Once the sunroof has reversed to the soft stop, immediately (within 5 seconds of stopping travel) release the "CLOSE" button and continuously press it again.
4. After a delay of three seconds the sunroof will begin moving to the "OPEN and then "CLOSED position. When the roof reaches the fully "CLOSED" position and stops the close button can be released.

The Re-initialization procedure is now complete. Operate the sunroof in all directions to verify proper operation.