Power

REMOVAL
1. Remove the waterdam.

Door Glass/Regulator:

2. Raise the glass to the position shown and using a long flat blade or hook type tool, disengage clips attaching glass retainer to regulator lift plate.
3. Disconnect the glass from the regulator lift plate and re-install the clips.
4. Secure the glass in the up position using a wood wedge, tape or equivalent.

Window Regulator - Electric:

5. Loosen the bolts.
6. Disconnect the runout tube clip.
7. Disconnect the electrical connector and remove the regulator.

INSTALLATION
1. Install the regulator assembly.
2. Connect the electrical connector.

Reulator Tightening Sequence Power:

3. Tighten the bolts to 9 N.m (80 in.lbs.) using the sequence shown.
4. Connect the runout tube clip.
5. Remove the glass support and connect to the regulator lift plate.
6. Install the waterdam.