Crankshaft Position Sensor: Service and Repair

REMOVAL
1. Disconnect negative battery cable.
2. Raise vehicle on hoist.
3. Remove exhaust pipe to turbocharger down pipe retaining bolts and lower exhaust pipe from turbocharger downpipe.
4. Disconnect crankshaft position sensor electrical connector.
5. Remove the heat shield.

Crankshaft Position (CKP) Sensor Removal/Install:

6. Remove crankshaft position sensor retaining bolt and remove sensor from engine block.

INSTALLATION

Crankshaft Position (CKP) Sensor Removal/Install:

1. Lubricate O-ring on crankshaft position sensor and install sensor in engine block.
2. Install crankshaft position sensor retaining bolt. Torque bolt to 10.8 N-m.(95 in.lbs.).
3. Connect crankshaft position sensor electrical connection.
4. Install the heat shield. Tighten fasteners to 10.8 N-m.(95 in.lbs.).
5. Connect exhaust pipe to turbocharger downpipe. Torque bolts to 32.4 N-m.(24 ft.lbs.).
6. Lower vehicle from hoist.
7. Connect negative battery cable.