Fluid Pressure Sensor/Switch: Service and Repair

SOLENOID/PRESSURE SWITCH ASSY

REMOVAL

NOTE: If the Solenoid/Pressure Switch Assembly is being replaced, the Quick Learn Procedure must be performed.

1. Raise vehicle on hoist.
2. Remove valve body assembly from transmission.





3. Remove Solenoid/Pressure Switch Assembly retaining screws (2) from solenoid (Fig. 239).





4. Remove Solenoid/Pressure Switch Assembly (1) and screen from valve body (2) (Fig. 240).

INSTALLATION

NOTE: If the Solenoid/Pressure Switch assembly is being replaced, the Quick Learn Procedure must be performed.





1. Install Solenoid/Pressure Switch Assembly (1) (Fig. 241) and screen (3) to the separator and transfer plates.





2. Install and tighten retaining screws (2) (Fig. 242) to 5.5 Nm (50 inch lbs.) torque.
3. Install valve body.