Shift Lever Code
P0562-BATTERY VOLTAGE LOW - ESMTheory of Operation
The Shift Lever Assembly monitors ignition voltage. The DTC will set if the monitored battery voltage drops below 6.0 volts and a temporary limp in will be activated. If the voltage rises above 9.0 volts, normal operations is resumed.
- When Monitored:
Continuously with the ignition on.
- Set Condition:
When monitored battery voltage drops below 6.0 volts.
Possible Causes
VEHICLE CHARGING SYSTEM
(F1) IGNITION UNLOCK RUN START CIRCUIT
(Z911) GROUND CIRCUIT
SHIFT LEVER ASSEMBLY
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1. CHECK FOR ENGINE CHARGING SYSTEM DTCS
With the scan tool, read Engine DTCs.
Are there any Engine Charging System DTCs present?
Yes >>Refer to Charging System/Testing
No >>Go To 2
2. CHECK (F1) IGNITION UNLOCK RUN START CIRCUIT
Turn the ignition off to the lock position.
Disconnect the Shift Lever Assembly harness connector. Turn the ignition on.
Using a 12-volt test light connected to ground, check the (F1) Ignition Unlock Run Start circuit in the Shift Lever Assembly harness connector.
NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.
Does the test light illuminate brightly?
Yes >>Go To 3
No >>Repair the (F1) Ignition Unlock Run Start circuit for high resistance. Perform NAG1 TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests
3. CHECK (Z911) GROUND CIRCUIT
Turn the ignition off to the lock position.
Using a 12-volt test light connected to 12-volts, check the (Z911) Ground circuit in the Shift Lever Assembly harness connector.
NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.
Does the test light illuminate brightly?
Yes >>Go To 4 Perform NAG1 TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests
No >>Repair the (Z911) Ground circuit for high resistance. Perform NAG1 TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests
4. SHIFT LEVER ASSEMBLY
Reconnect all disconnected harness connectors.
With the scan tool, erase Shift Lever DTC's.
Start the engine and raise the engine speed to 2000 RPM.
With the scan tool, read Shift Lever DTC's.
Did the P0562-BATTERY VOLTAGE LOW DTC reset?
Yes >>Replace the Shift Lever Assembly. Perform NAG1 TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests
No >>Test Complete.