Latch-Liftgate Glass
LATCH-LIFTGATE GLASSREMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the liftgate (1).
NOTE: Grand Cherokee (WK) shown, Commander (XK) similar.
3. Using a grease pencil or equivalent, mark the position of the latch to aid installation.
4. Disconnect the electrical connectors (1) from the liftgate glass latch (3).
5. Remove the two nuts (2) that secure the latch (3) to the inside of the liftgate.
6. Remove the liftgate glass latch (3) from the vehicle.
INSTALLATION
NOTE: Grand Cherokee (WK) shown, Commander (XK) similar.
1. Position the latch (3) into the inside of the liftgate and align using the marks made during removal.
2. Install and tighten the three bolts (2). Tighten the bolts to 12 N.m (9 ft.lbs).
3. Connect electrical connectors (1) to the latch (3).
4. Check and adjust the glass position, if necessary.
5. Install the trim panel.
6. Connect the battery negative cable.