A-Pillar Trim

PANEL-A-PILLAR TRIM/GRAB HANDLE

REMOVAL




1. Using a small flat-bladed tool, carefully open the two fastener covers located in the A-pillar trim panel.
2. Remove the two bolts that secure the A-pillar trim panel to the A-pillar and remove the trim panel.

INSTALLATION




1. Position the locating tabs of the A-pillar trim panel into the slots located in the top of the instrument panel.
2. Install the A-pillar trim panel onto the A-pillar and install the two bolts. Tighten the bolts to 6 N.m (55 in.lbs).
3. Close the two fastener covers located in the A-pillar trim panel.