D-Pillar Trim

PANEL-D-PILLAR TRIM

REMOVAL




1. Remove the rear header molding, Refer to Trim Panel.




2. Using a trim stick C-4755 or equivalent, disengage the retaining tabs that secure the D-pillar trim panel to the retaining clips in the D-pillar and remove the trim panel.




3. Separate the seat release cable clip (2), remove the cable housing from the bracket (3) and disconnect the cable (1).

INSTALLATION




1. Connect the seat release cable (1), secure the cable housing into the bracket (3) and secure the clip (2).




2. Position the locating tabs on the bottom of the D-pillar trim panel into the slots in the top of the quarter trim panel.
3. Align the retaining tabs on the D-pillar trim panel with the retaining clips in the D-pillar and engage the retaining tabs that secure the trim panel to the D-pillar.




4. Install the rear header molding.