Third Row

SEAT-THIRD ROW

REMOVAL




1. Remove the cargo load floor (1).




2. Remove the inner nut and bolt (2).
3. Remove the outer nuts (3).
4. Lift seat assembly up off of the studs (1) and release the front hooks from the strikers (4).
5. Remove the seat.




6. Remove the bolt (5) and remove the lower seat belt anchor (4).

INSTALLATION




1. Position the seat belt lower anchor (4) to the outboard rear corner of the third row seat support bracket (1). Be certain that the belt webbing is not twisted between the top of the seat back and the lower anchor.
2. Install and tighten the screw (5) that secures the lower anchor to the seat support bracket. Tighten the screw to 43 N.m (32 ft.lbs).




3. Position the seat into the vehicle and align the front hooks with the strikers (4).
4. Position the rear of the seat over the rear studs and locator pins (1).
5. Install the center nut and bolt (2) and tighten to 50 N.m (37 ft.lbs).
6. Install the outer nuts (3) and tighten to 50 N.m (37 ft.lbs).




7. Install the cargo load floor.