Rear

REAR

REMOVAL





1. Raise and support the vehicle.
2. Remove wheel and tire assembly
3. Remove the caliper slide bolts (4).





4. Remove caliper (1).
5. Secure caliper assembly (1) to nearby suspension part with wire. Do not allow brake hose to support caliper weight.





6. Remove and discard the o-ring (2) securing rotor (1) to axle studs.
7. Remove rotor (1) off axle studs.

INSTALLATION

1. Install rotor on axle studs.





2. Install the caliper assembly
3. Install caliper slide bolts (4) and tighten to 44 Nm (32 ft. lbs.).





4. Install wheel and tire assembly
5. Remove support and lower the vehicle.
6. Pump brake pedal until caliper pistons and brake shoes are seated.