Rear Door Window Glass: Service and Repair

GLASS

REMOVAL




1. Remove the watershield from the inside of the rear door. Refer to Rear Door Panel.




2. Separate and remove the inner belt molding.
3. Temporarily install the window switch and raise the glass into the full up position.
4. Remove the bolts and remove the glass run channel. Refer to Window Track.
5. Loosen the bolt in each of the window regulator glass clamps just far enough to release the door glass from the clamps. Do not completely remove.
6. Disengage the door glass from the window regulator glass clamps.
7. Lower the regulator down as required for access to remove the door glass.
8. Carefully rotate the door glass within the window opening and remove the glass from the door through the window opening.

INSTALLATION




1. Carefully lower the door glass into the rear door through the window opening.
2. Rotate the door glass into position and engage it to the window regulator glass clamps.
3. Using the regulator (2), move the rear door glass to full up.
4. Tighten the bolts in each of the window regulator glass clamps to 12 N.m (105 in.lbs).
5. Install the glass run channel. Refer to Window Track.




6. Install the watershield onto the inside of the rear door.
7. Position and seat the inner belt molding fully.