Rear Door Window Regulator: Service and Repair

REGULATOR-WINDOW

REMOVAL




1. Remove the watershield.




2. Temporarily install the window switch and position the glass fully up to gain access to the glass clamp screws.
3. Tape the glass securely into place.
4. Loosen the bolt in each of the window regulator glass clamps just far enough to release the door glass from the clamps. Do not completely remove.
5. Remove the bolts (1 and 4) that secure the window regulator rail to the inside of the door.
6. Disconnect the electrical connector (3).
7. Lower the regulator and remove the regulator from the door.

INSTALLATION




1. Load the window regulator into the rear door through the large access hole in the door and connect the wire harness connector (3) to the regulator motor.
2. Engage the glass into regulator clamps.
3. Install the bolts (1 and 2) that secure the regulator rails to the door. Tighten the bolts to 8.5 N.m (75 in. lbs.).
4. Carefully remove the tape securing the door glass in its full up position.
5. Temporarily install the window switch and raise the glass into the full up position.
6. Tighten the bolts in each of the window regulator glass clamps to 12 N.m (105 in. lbs.).
7. Install the watershield and the trim panel onto the inside of the front door.




8. Install the watershield (1).