Air Cleaner Housing: Service and Repair

Housing Assembly

REMOVAL





NOTE: Always unplug the Charge Air Temperature sensor before removing the resonator.

1. Loosen clamp and disconnect air duct at air cleaner cover.
2. Lift entire housing assembly (1)from 4 locating pins (2).

INSTALLATION
1. Install filter element into housing.
2. Position housing cover into housing locating tabs.
3. Pry up 4 spring clips and lock cover to housing.
4. Install air duct to air cleaner cover and tighten hose clamp to 5 Nm (45 inch lbs.) torque.
5. If any other hose clamps were removed from air intake system, tighten them to 5 Nm (45 inch lbs.) torque.
6. If any bolts were removed from air resonator housing or air intake tubing, tighten them to 5 Nm (45 inch lbs.) torque.