Pressure Line - Fan to Gear
PRESSURE LINE - FAN TO GEARREMOVAL
1. Siphon the power steering fluid from the reservoir.
2. Raise and support the vehicle.
3. Remove the front skid plate.
4. Remove the pressure line (2) at the gear (1).
5. Remove the quick connect pressure line (6) from the hydraulic cooling fan (4) using special quick connect tool 8875-A.
6. Remove the pressure line (6) from the vehicle.
INSTALLATION
1. Install the pressure line (5) to the vehicle.
2. Install the pressure line (5) at the hydraulic cooling fan (4).
3. Install the pressure line (2) at the gear (1), Tighten to 28 Nm (21 ft. lbs.).
4. Install the front skid plate.
5. Lower the vehicle.
6. Fill the system with power steering fluid and bleed.