Control Module: Service and Repair

MODULE-FINAL DRIVE CONTROL

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Lift up rear seat to expose the park assist module and final drive control module.




3. Disconnect the module electrical connector (1).
4. Using a trim stick (special tool #C-4755) or equivalent, gently pry back on the retaining tabs on the mounting plate (2) and remove module.

INSTALLATION




1. Place the final drive control module (3) in its location on the mounting plate (2) and firmly snap into place.
2. Connect the electrical connector (1).




3. Lower the rear seat back down into position.
4. Connect the battery negative cable.