Seal-Rear Output Shaft

SEAL-REAR OUTPUT SHAFT

REMOVAL





1. Remove the rear propeller shaft.
2. Using Holder C-3281 (1), remove the rear companion flange (2) nut.





3. Remove the rear output flange (1) from the main shaft (2). If necessary, use a suitable 2 or 3 jaw puller to remove the output shaft flange.
4. Remove the rear output seal with a suitable pry tool or a screw mounted in a slide hammer.

INSTALLATION





1. Install a new rear output seal into the rear cover with Installer 6952-A.
2. Install the rear output flange (1) onto the main shaft (2).





3. Using Holder C-3281 (1), install the rear companion flange (2) nut. Tighten the nut to 122 - 176 Nm (90 - 130 ft. lbs.).
4. Install the rear propeller shaft.
5. Check the transfer case fluid level. Correct as necessary.