B1638
B1638-RIGHT HI BEAM CONTROL CIRCUIT HIGHB1638-Right Hi Beam Control Circuit High:
WHEN MONITORED
With the Headlamps activated.
SET CONDITION
When the FCM detects a HIGH condition.
POSSIBLE CAUSES
- (L34) high beam control circuit
- Right high beam bulb
- Front control module
DIAGNOSTIC TEST
1. INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all FCM DTC's.
Turn the Headlamps on.
With the Scan Tool read the DTC information.
Q: Does the Scan Tool read: B1638-RIGHT HI BEAM CONTROL CIRCUIT HIGH?
YES: Go To 2
NO: The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
2. RIGHT HIGH BEAM BULB
Turn the ignition off.
Inspect the Right High Beam Bulb Assembly.
Q: Is the inoperative bulb OK?
YES: Go To 3
NO: Replace the Inoperative bulb.
Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
3. (L34) HIGH BEAM CONTROL CIRCUIT
Turn the ignition off.
Disconnect the FCM C2 harness connector.
Measure the resistance of the (L34) High Beam Control circuit.
Q: Is the resistance above 5.0 ohms?
YES: Repair the (L34) High Beam Control circuit for a short to battery condition.
Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: Replace the Front Control Module (FCM).
Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test