B213B

B213B-IGNITION RUN (REMOTE START) CONTROL CIRCUIT LOW

WHEN MONITORED
With the ignition on.

SET CONDITION
The Front Control Module is not configured correctly setting a false DTC that does not apply to this vehicle.

POSSIBLE CAUSES
- Front control module not configured correctly

DIAGNOSTIC TEST

1. CHECK FOR ACTIVE DTC AND DETERMINE FCM CONFIGURATION
With the scan tool, read the active DTC's.
Cycle the ignition switch from off to on at least 5 times, leaving the ignition on for a minimum of 90 seconds per cycle.
With the scan tool, read the active DTC's.

Q: Does the scan tool display this DTC as active?

YES: With the scan tool enter program network configuration and program the FCM to the vehicle configuration, erase DTC's and retest.
NO: If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals. Erase the stored DTCs.