C1219

C1219 - STEERING ANGLE SENSOR ERRATIC PERFORMANCE






- When Monitored:
With the ignition on.

- Set Condition:
When the Anti-Lock Brake Module detects a calculated steering wheel angle more than physically possible.







Diagnostic Test


1. CHECK FOR A DTC C1219 - STEERING ANGLE SENSOR ERRATIC PERFORMANCE

NOTE: This DTC must be active for the results of this test to be valid.

Turn the ignition on.

With the scan tool, read and record DTCs.

With the scan tool, read and record Freeze Frame information.

With the scan tool, erase DTCs.

Graph steering angle while turning the steering wheel from lock to lock.

Cycle the ignition switch from off to on.

With the scan tool, read and record DTC's.

Does the scan tool display: C1219-STEERING ANGLE SENSOR ERRATIC PERFORMANCE?

Yes

- Go To 2.

No

- Refer to the Intermittent Condition Diagnostic Procedure.
- Perform ABS VERIFICATION TEST. ABS Verification Test

2. CHECK FOR ALL STEERING ANGLE CODES

Were any steering angle codes found?

Yes

- Replace Steering Control Module.
- Perform ABS VERIFICATION TEST. ABS Verification Test

No

- Go To 3.

3. CHECK THE TERMINALS/CONNECTORS/WIRING HARNESS FOR DAMAGE

Check the Steering Angle Sensor installation.

Check all related wiring for bruised, chafed, pierced, or partially broken wires.

Check all related connectors for broken, pushed out, or corroded terminals.

Were any problems found?

Yes

- Repair as necessary.
- Perform ABS VERIFICATION TEST. ABS Verification Test

No
- Go To 4.

4. CHECK THE VOLTAGE ON THE (A108) FUSED B(+) CIRCUIT






Turn the ignition off.

Disconnect the Steering Angle Sensor harness connector.

Turn the ignition on.

Measure the voltage of the (A108) Fused B(+) circuit.

Is the voltage above 10 volts?

Yes
- Go To 5.

No
- Repair the (A108) Fused B(+) circuit for an open.
- Perform ABS VERIFICATION TEST. ABS Verification Test


5. CHECK THE RESISTANCE OF THE (Z907) GROUND CIRCUIT






Turn the ignition off.

Measure the resistance between the (Z907) Ground circuit and ground.

Is the resistance below 5.0 ohms?

Yes

- Replace Steering Control Module.
- Perform ABS VERIFICATION TEST. ABS Verification Test

No

- Repair the (Z907) Ground circuit for an open.
- Perform ABS VERIFICATION TEST. ABS Verification Test