Rear Defogger Relay: Service and Repair

REMOVAL
1. Disconnect and isolate the negative battery cable.

Power Distribution Center (PDC):

2. Open the cover of the power distribution center PDC located in the engine compartment.

NOTE: Refer to the fuse and relay layout map on the inside of the PDC cover for EBL relay location.

3. Remove the EBL relay from the PDC.

INSTALLATION

NOTE: Refer to the fuse and relay layout map on the inside of the power distribution center PDC. cover for EBL relay location.

1. Position the EBL relay to the proper receptacle of the PDC.
2. Align the EBL relay terminals with the terminal cavities in the PDC and push down firmly on the relay until the terminals are fully seated.
3. Close the cover of the PDC.
4. Reconnect the negative battery cable.