Transmission Position Sensor/Switch: Service and Repair
AUTOMATIC TRANSMISSION - 42RLETRANSMISSION RANGE SENSOR
REMOVAL
1. Remove valve body assembly from vehicle.
Fig. 253 Manual Shaft Seal - Typical:
2. Remove the manual shaft seal (1) (Fig. 253).
Fig. 254 Manual Shaft Retaining Screw:
3. Remove manual shaft/TRS retaining screw (1) (Fig. 254).
4. Slide TRS off of manual valve shaft.
INSTALLATION
1. Install the TRS (2) to the manual shaft. Make sure TRS locating pin rests in manual valve bore slot.
Fig. 255 Manual Shaft Retaining Screw:
2. Install the TRS/manual shaft retaining screw (1) (Fig. 255) and torque to 5 Nm (45 inch lbs.) torque.
Fig. 256 Manual Shaft Seal - Typical:
3. Install the manual shaft seal (1) (Fig. 256).
4. Install valve body to the transmission.