Installation

INSTALLATION




1. Install the knuckle (1) to the vehicle.
2. Install the lower ball joint into the knuckle.
3. Install the lower ball joint nut. Tighten the nut to 95 Nm (70 ft.lbs.).




4. Install the upper ball joint (2) into the knuckle (3)
5. Install the upper ball joint nut (4). Tighten the nut to 95 Nm (70 ft.lbs.).




6. Install the outer tie rod end to the steering knuckle.




7. Install the hub/bearing (3), Tighten to 115 Nm (85 ft.lbs.).
8. Install the axle shaft nut. Tighten the nut to 135 Nm (96 ft.lbs.).(if equipped with four wheel drive).
9. Install the wheel speed sensor (2) and reclip the wire to the knuckle.




10. Install the disc brake rotor (1).




11. Install the caliper adapter (1).
12. Install the tire and wheel assembly.
13. Perform wheel alignment.