Bulb - Rear

BULB - REAR

NOTE: The rear dome lamp is integral to the optional Intrusion Transceiver Module (ITM); therefore, only vehicles equipped with an ITM have a rear dome lamp.




1. Disconnect and isolate the battery negative cable.

2. Insert the tip of a small flat-bladed screwdriver into the notch (4) on one side of the Intrusion Transceiver Module (ITM) housing (1) between the rear dome lamp lens (2) and the lamp housing.

3. Gently pry the notched edge of the lens downward until it unsnaps from the housing.

4. Swing the notched end of the lens downward far enough to access the bulb (3).

5. Carefully unsnap the bulb from the two bulb holders within the lamp housing.