Bulb - Rear

BULB - REAR

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

NOTE: The rear dome lamp is integral to the optional Intrusion Transceiver Module (ITM); therefore, only vehicles equipped with an ITM have a rear dome lamp.




1. Align the ends of the bulb (3) with the two bulb holders within the lamp housing of the Intrusion Transceiver Module (ITM) housing (1).

2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.

3. Swing the notched end of the rear dome lamp lens (2) up into position against the lamp housing, then press upward on the lens firmly and evenly until it snaps into the housing.

4. Reconnect the battery negative cable.