Removal

REMOVAL

Without APPS (Accelerator Pedal Position Sensor)





The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles not equipped with an accelerator pedal position sensor.

The accelerator pedal is serviced as a complete assembly including the bracket.

1. From inside the vehicle, hold up accelerator pedal. Remove plastic cable retainer (clip) (2) and throttle cable core wire from upper end of accelerator pedal arm. Plastic cable retainer (clip) (2) snaps into top of pedal arm.




2. Remove two accelerator pedal mounting bracket nuts (3). Remove accelerator pedal assembly (2).

With APPS (Accelerator Pedal Position Sensor)





The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles equipped with an accelerator pedal position sensor (6).

The accelerator pedal is serviced as a complete assembly including the bracket.

1. Disconnect electrical connector (3) at APPS (6).

2. Remove two accelerator pedal mounting bracket nuts (4). Remove accelerator pedal assembly.

3. Remove three sensor-to-pedal nuts (5). Remove APPS from accelerator pedal assembly.