Installation

INSTALLATION




1. Install a new intake manifold to throttle body gasket (2), if replacement was necessary.

2. Install four new four j-nuts (1), if replacement was necessary.





CAUTION: DO NOT OVER TORQUE. Over tightening can cause damage to the throttle body, gaskets, bolts and/or the intake manifold.

3. Install throttle body (1) to intake manifold (2).

4. Install four bolts (4) and hand tighten.

5. Connect throttle body (1) electrical connector (3).





CAUTION: The throttle body must be torqued in a mandatory torque sequence. Tighten in a criss - cross pattern to specification.

6. Tighten the bolts in a mandatory torque criss - cross pattern sequence to 7.5 Nm (65 in. lbs.).

7. Install throttle body air intake hose and tighten clamps.

8. Connect negative battery cable, tighten nut to 5 Nm (45 in. lbs.).

9. Use a scan tool and select the ETC RELEARN function to relearn the APPS values.