Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2008 >> Commander 2WD V6-3.7L >> Repair and Diagnosis >> Body and Frame >> Seats >> Seat Temperature Element >> Service and Repair >> Heated Seat Element - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Heated Seat Element - Installation







INSTALLATION





1. Peel off the adhesive backing on the back of the replacement heating element (2) and stick directly on top of the factory installed heating element (1).

CAUTION: During the installation of the replacement heating element, be careful not to fold or crease the element assembly. Folds or creases will cause premature failure.





2. Connect the new heating element electrical connectors (3&4).
3. Connect the battery negative cable.
4. Verify heated seat system operation.
5. Install the appropriate seat cushion, Seat Cushion / Cover - Installation or seat back trim cover, Seat Back Cushion / Cover - Installation.

NOTE: Make certain the seat wire harness is correctly routed through the seat and seat back. The excess wire between the cushion and back elements should be securely tucked between the rear of the cushion foam and the rear carpet flap of the trim cover.
pro multis · About Operation CHARM