Installation

INSTALLATION





NOTE: If a bearing flange stud is loose or has backed out tighten stud to 27 Nm (20 ft. lbs.).

1. Install axle flange bolts into axle flange.
2. Install axle shaft into the axle bearing.
3. Install axle shaft (1) with bearing into axle tube and backing plate with new o-ring on axle.




4. Slip O-ring (2) through backing plate, then push the bearing through backing plate until bearing (1) is exposed.
5. Install new O-ring (2) axle bearing.




6. Push axle into axle tube.
7. Install axle (2) flange nuts (1) and tighten to 119 Nm (88 ft. lbs.).




8. Install speed sensors (2) in axle tube (1) flange.
9. Install calipers and rotors.