Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2008 >> Commander 2WD V8-4.7L >> Repair and Diagnosis >> Body and Frame >> Doors, Hood and Trunk >> Trunk / Liftgate >> Trunk / Liftgate Position Sensor >> Service and Repair >> Power Liftgate Full Open Switch - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Power Liftgate Full Open Switch - Installation







INSTALLATION





CAUTION: Be certain the wires are reinstalled in the correct wire cavities. Failure to do so could result in damage to components. Refer to Wiring Diagrams if uncertain.

1. Position the full open switch (2) onto the power liftgate drive unit assembly (1) and install the retaining screw (3).




2. Ensure the full open switch wire harness (3) is routed properly through the power liftgate drive unit routing tabs (2).




3. Carefully install the full open switch wire harness routing clips (2) into the power liftgate drive unit assembly (1).




4. Insert the full open switch wire terminals (2) into the liftgate drive unit connector (1) ensuring the proper terminal location as noted in the full open switch removal procedure.
5. Install the power liftgate drive unit assembly on the vehicle, Power Liftgate Drive Unit - Installation.
6. Connect the battery negative cable.
7. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
8. Perform the power liftgate learn cycle, Power Liftgate Learn Cycle.
9. Verify power liftgate system operation.
pro multis · About Operation CHARM