Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2008 >> Commander 2WD V8-4.7L >> Repair and Diagnosis >> Body and Frame >> Roof and Associated Components >> Sunroof / Moonroof >> Service and Repair >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation







INSTALLATION





WARNING: The Excessive Force Limitation (EFL) feature must be calibrated any time a sunroof motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or personal injury. Sunroof Position Calibration

1. Verify that glass panel is loose and slightly retracted.
2. Raise sunroof module assembly and guide it carefully into position.
3. Hand start the eight screws (3).
4. Line up the locating holes and tighten the attaching screws (3) to 9 Nm (80 in. lbs.).




5. Install the DVD support bracket (3), if equipped.
6. Install the bolts (2) and tighten to 9 Nm (80 in. lbs.).
7. Install the bolts (1) and tighten to 10 Nm (85 in. lbs.).




8. Connect the electrical connector (2) and seat the three support clips (1) fully.




9. Connect the front (1) and rear (2) drain tubes to the sunroof.
10. Adjust the sunroof glass. Adjustments
11. Connect battery negative cable.
12. Install the vehicle headliner, Headliner - Installation.
13. Perform the sunroof position calibration, Sunroof Position Calibration.
14. Perform the Excessive Force Limitation (EFL) calibration, Sunroof Position Calibration.
15. Verify proper operation of the power sunroof system.
pro multis · About Operation CHARM