Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2008 >> Grand Cherokee 2WD V8-5.7L >> Repair and Diagnosis >> Lighting and Horns >> Headlamp >> Headlamp Alignment Sensor >> Service and Repair >> Installation >> Front
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front







FRONT





1. Check to be certain that the two plastic nuts (5) are properly installed and in good condition in the right front wheel house sheet metal.
2. Position the front axle sensor, brackets and link unit (4) into the wheel house as a unit.
3. Install and tighten the two screws (3) that secure the mounting bracket to the right front wheel house. Tighten the screws to 10.5 Nm (95 in. lbs.).
4. Install and tighten the screw (2) that secures the sensor link bracket to the right front upper control arm (1) near the rear pivot bushing. Tighten the screw to 4 Nm (35 in. lbs.).
5. Engage the vehicle wire harness routing clips to the sensor bracket.
6. Reconnect the vehicle wire harness connector (6) to the sensor connector receptacle.
7. Lower the vehicle.
8. Reconnect the battery negative cable.
pro multis · About Operation CHARM