42RLE Automatic Transmission

U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE (TIPM)






For a complete wiring diagram, refer to the wiring information Electrical Diagrams

- When Monitored:

Ignition run time is greater than 1 second. Battery voltage between 9 and 16 volts.

- Set Condition:

The PCM doesn't receive a TIPM message over the CAN C circuit for 7 consecutive seconds. The circuit is continuously monitored. One Trip fault.






ACTIVE DTC

1. Ignition on, engine not running.
2. With a scan tool, select View PCM DTCs.

Is the DTC Active at this time?

Yes

- Diagnose and repair the DTC(s). Refer to Electrical/Electronic Control Modules-Diagnosis and Testing for diagnostic procedure and for further possible causes.

No

- Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Intermittent Condition