B1E6B

B1E6B-PASSENGER MIRROR FOLD CONTROL CIRCUIT LOW

For a complete wiring diagram, refer to the wiring information Electrical Diagrams.

- When Monitored:
Continuously.





1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, erase all the DTCs.
3. Operate the Mirror Fold switch several times.
4. Cycle the ignition from on to off three times.
5. Turn the ignition on.
6. With the scan tool, read the DTCs.

Does the scan tool display active: B1E6B-PASSENGER MIRROR FOLD CONTROL CIRCUIT LOW?

Yes

- Go To 2

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded or contaminated terminals. Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. INSPECT MIRROR CONNECTIONS
1. Turn the ignition off.
2. Disconnect the Passenger Outside Rearview Mirror connector at the Passenger Door Module harness connector.
3. Inspect the wiring and connectors between the mirror and the Passenger Door Module.

Were there any problems found?

Yes

- Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. MIRROR ASSEMBLY
1. Turn the ignition off.
2. Replace the Passenger Outside Rearview Mirror Assembly.
3. Turn the ignition on.
4. Operate the Mirror Fold switch several times.
5. With the scan tool, read the DTCs.

Does the scan tool display active: B1E6B-PASSENGER MIRROR FOLD CONTROL CIRCUIT LOW?

Yes

- Replace the Passenger Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test Complete.
- Perform the BODY VERIFICATION TEST. Body Verification Test.