Installation
INSTALLATION
1. Before proceeding with the following repair procedure, review all warnings and cautions.
2. Position the cluster bezel up over the steering column and tuck the seal (1) behind the upper column cover (2).
3. Position the ducts (3) into the instrument panel.
4. Seat the cluster bezel and seat the lower clips (2) fully.
5. Install the screw (1).
6. Install the A-pillar trim (3).
7. Position the top cover (1) over the cluster bezel and opposite side top cover (3).
8. Seat the rear clips (6) fully.
9. Seat the clips into the top cover (3) and seat the remaining five clips (5) into the cluster bezel fully.
10. Position the center bezel (1) back into place and engage the lower clips (4).
11. Position the bezel up over the radio and seat the center and upper clips (2 and 3) fully.
12. Position the kneeblocker hinges (3) onto the instrument panel receivers (2) and slide the hinges (1) into place.
13. Position the top of the kneeblocker (2) up against the instrument panel and seat the clips (1) fully.