Rear Seat

ASSEMBLY

60/40 Seat Back- 40





1. Install the seat back cover to the seat back cushion and install new hog rings.
2. Install the cover and cushion to the seat back frame, pull the seat cover tight around the cushion and seat frame.
3. Install the head rest guides to the top of the seat cushion.
4. Install the left floor bracket to the seat frame.




5. Install the right hinge and bolts (1) to the seat back frame and tighten to 47.5 Nm (35 ft. lbs.).




6. Install the bracket (4), trim attachment bracket (2) and bracket nuts (1) to the hinge (3) and tighten to 47.5 Nm (35 ft. lbs.).




7. Install the recliner handle (3), washer (1) and screw to the floor bracket in the position noted during removal and tighten to 7 Nm (62 in. lbs.).




8. Install the trim covering and screw to the floor bracket and tighten to 3 Nm (26.5 in. lbs.).
9. Install the plastic seat cover clips to the seat back frame.
10. Install the hog ring attaching the seat back cushion to the seat frame.




NOTE: Replace any damaged clips as necessary. Failure to replace any missing or damaged clips could result in a noise complaint.

11. Install the seat back trim panel (1) to the seat back frame (2).

60/40 Seat Back - 60





1. Install the seat belt assembly and bolt to the seat back frame and tighten to 47.5 Nm (35 ft. lbs.).
2. Install the seat back cover to the seat back cushion and install new hog rings.
3. Feed the seat belt through the cushion and cover.
4. Install the cover and cushion to the seat back frame, pull the seat cover tight around the cushion and seat frame.

NOTE: Replace any head rest guide's damaged during removal.

5. Install the head rest guides to the top of the seat cushion.




6. Install the seat belt trim to the top of the seat back cushion.




7. Install the right hinge and bolts (1) to the seat back frame and tighten to 47.5 Nm (35 ft. lbs.).




8. Install the left hinge and bolts (1) to the seat back frame and tighten to 47.5 Nm (35 ft. lbs.).




9. Install the bracket (1), trim attachment bracket (2) and bracket nuts (3) to the hinge (4) and tighten to 47.5 Nm (35 ft. lbs.).




10. Install the trim covering and screw to the floor bracket and tighten to 3 Nm (26.5 in. lbs.).
11. Install the plastic seat cover clips to the seat back frame.




12. Install the seat back trim panel (1) to the seat back frame (2).