Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant Classification System (OCS), seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Disconnect and isolate the battery negative cable.
2. Remove the console from the floor panel transmission tunnel. Floor Console Base Tray - Removal.
3. Apply the parking brake lever mechanism (3).
4. Disconnect the wire harness connector (2) from the terminal of the park brake switch (1) located on the left side of the park brake lever mechanism.
5. Remove the screw (4) that secures the park brake switch to the park brake lever mechanism.
6. Remove the switch from the park brake lever mechanism.