Liftgate Trim Panel - Installation

INSTALLATION





1. Using hand pressure, press firmly and evenly on the upper trim panel (2) over each of the fastener locations until the fasteners are fully engaged in the holes on the inside of the liftgate.
2. Install the flip glass weather-strip.
3. Connect the battery negative cable.

4. Check to be certain that the fasteners are properly installed and in good condition on the inside of the trim panel.




5. Connect the lighting connector.
6. Position the top of the liftgate trim (1) onto the liftgate and seat the upper retaining clips (2) fully.
7. Using hand pressure, press firmly and evenly on the trim panel (1) over each of the six lower retaining clip locations (3) until the clips are seated fully in the holes on the inside of the liftgate.
8. Secure the trim panel (2) to the inside of the liftgate.