DRL and Position Lamp Bulb - Removal

BULB - DRL AND POSITION LAMP

WARNING: To avoid serious or fatal injury when working on the High Intensity Discharge (HID) headlamp system, be certain to take the proper precautions. The headlamp switch must be in the OFF position. Disconnect and isolate the battery negative cable. There is a risk of fatal injury caused by contact with high voltage used in the HID headlamps. There is a risk of explosion or fire caused by highly flammable materials in the vicinity of damaged HID lighting elements. There is a risk of injury caused by exposure to Ultra Violet (UV) light, a risk of burns caused by high component operating temperatures, a risk of mercury poisoning through glass splinters produced by bursting HID lighting elements. There is also a risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with the skin. Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on HID headlamps. Wear insulated safety shoes, safety glasses and protective gloves. Remove flammable materials and ensure sufficient ventilation in the working area.

NOTE: The following procedure applies only to vehicles with both the High Intensity Discharge (HID) headlamps and Daytime Running Lamps (DRL). This procedure also applies to the position lamp bulb for export markets only. Although the DRL and position lamp bulb type and location is the same in both domestic and export market vehicles, the position lamp function is disabled in domestic market vehicles where that function is performed by the amber front park lamp bulb. Vehicles equipped with halogen headlamps (domestic market only) modulate either the low beam (Canada) or high beam (U.S. fleet) headlamp bulb to serve as the DRL.




High Intensity Discharge (HID) - Domestic



High Intensity Discharge (HID) - Export
1. Remove the front lamp unit from the front of the vehicle. Front Lamp Unit - Removal.
2. Firmly grasp the Daytime Running Lamp (DRL) and position lamp bulb socket (5) on the back of the front lamp unit housing (1) and rotate it counterclockwise about 30 degrees to unlock it.
3. Pull the socket and bulb straight out from the keyed opening in the housing.
4. Pull the base of the bulb straight out of the socket.